Filament Dyeing | Hackaday

Filament Dyeing | Hackaday

Manufacturers dye all kinds of 3D printer filament on their factory lines. why can’t we [Richard] goes one step further and creates its own multi-colored nylon rollers. Printing with these rolls creates a living pattern that simply demands our attention and asks us: how on earth?

[Richard’s] Tie-dye adventure is neatly documented in the blog. He simply spools up a roll of nylon and dyes subsections of the spool a different color. When the filament is “palletized” to taste, parts of the printer will burst with a noticeable rib pattern.

It is worth noting that nylon is extremely hygroscopic, and dyeing filaments in a bath full of colored liquid is sure to add moisture. On the other hand, the ability of nylon to absorb water could be why it stains so well. Even so, the filament must be oven dried (or equivalent) to print successfully. After drying, [Richard] doesn’t seem to have any printing issues and the results speak for themselves

3D printers may be frequent fliers on these sites, but we still love to see small changes that improve visual appeal. In addition, this trick produces spectacular results without any changes to the printer. If this job is just too much work for you, we recommend using a felt-tip pen.

Continue reading “Tie-Dyed Filament Sings With Color”

Source Link

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *