Blog

a 3d printed filament spool holder

EinW 3D filament sample spool holder

These are loose spools of filament that are held together with three cable ties and are quite stubborn once the cable ties are loosened.

The sample spool holders at Thingiverse were either too small for the 165mm ID or adjustable but complex.

With Design Spark Mechanical, it didn’t take long to create a design for a coil on the 8mm diameter rod (see why 8mm below) that I use as the coil center, and then about three hours to corner it Corner to be printed on a 150 x 150mm Ender 2.

Related Posts